© Zennio Avance y Tecnología S.L. Edition 5 Further information at www.zennio.com Page 1 / 2
InZennio Z41
InZennio Z41. Capacitive color touch panel
ZN1VI-TP41C Technical Documentation
CHARACTERISTICS
4.1’’ capacitive color touch panel.
LCD display of 16 million colors.
Up to 6 configurable pages.
48 configurable direct control and/or indicator functions.
2 independent thermostats.
Additional screens to control:
Configuration.
Tools.
Built-in temperature sensor.
Real Time Clock (RTC) with watch battery.
External power supply 12-29VDC needed.
KNX BCU integrated.
Connections: Ethernet RJ45 4 poles/USB.
Magnetic fit.
Complete Data Saving in case of Power Failure.
CE directives compliance.
4. External power
supply connector
GENERAL SYSTEM SPECIFICATIONS
Electric Operation Control device
Typical bus connector TP1, 0,50 mm² section
12- 29 VDC. Maximum consumption: 150mA (12VDC), 76mA (24VDC), 63mA (29VDC). For
minimum consumption use 12VDC.Do not connect 29VDC KNX bus as external power
supply
Ambient humidity (relative)
30 to 85% RH (no condensation)
Storage humidity (relative)
30 to 85% RH (no condensation)
Complementary characteristics
Electrical solicitations period
Nº of Automatic cycles per auto action
Independent Control Assembly device. Vertical position, with the temperature sensor to the
bottom. Magnetic fit. See Installation and Connection Diagram
Keep away from heat and cold air flows to get better temperature sensor measures
Response to bus voltage failure
Complete data saving. Initialization screen.
Response to bus failure recovery
Before failure data recovery
Response to external power supply failure
Complete data saving. Display is switched off
Response to external power supply failure recovery
Several on display as programmed
RJ45 Connector cable (included). Mini USB A-B cable Ref. ZN1AC-UPUSB (not included)
190 gr. Without metallic piece / 230 gr. With metallic piece
PC+ABS FR V0 halogen free
POWER SUPPLY AND PORTS SPECIFICATIONS AND CONNECTIONS
External power supply connection
Cable screw terminal and matching socket
RJ45 connector with 4 poles: Rx(+), Rx(-), Tx(+) and Tx(-).
To use this port, consult the Manual for Firmware Update at www.zennio.com.
Mini USB Type A connector. Version 2.0. Use this port only for firmware updates. Consult the Manual for
Firmware Update at www.zennio.com.
Do not connect to PC, hard drives or other devices with consumption higher than 150 mA.
Programming button: a push button to set the programming mode. If this button is held while
plugging the device into the KNX bus, it goes into safe mode.
Programming LED: programming mode indicator (red). When the device goes into safe mode, it
blinks (red) every half second.
Kommentare zu diesen Handbüchern