Zennio Z41 Handbuch PDF herunterladen (Seite 42)

ZENNiO AVANCE Y TECNOLOGÍA _vwww.zennio.com

The following describes how the Z41 reacts to an alarm:

When the Z41 receives the trigger value via the object “[Alarms – Box y] Alarm”, the corresponding

alarm is activated. The Z41 will then display the Alarms page and a danger icon will appear in the

corresponding alarm box. The display will begin to flash and a warning “beep” will be emitted to

attract the attention of the user. This behavior will continue until the corresponding OK button is

pressed, and the alarm is confirmed by sending the value “1” via the object “[Alarms – Box y]

Confirmation”. The Z41 will return to its normal state.

It is very Important to understand that confirming an alarm does not make the Danger icon

disappear from the box affected. This icon will only disappear from the display when the detection

device sends its “normal status”, i.e. when the Z41 receives the opposite value to the trigger via the

object “[Alarms – Box y] Alarm”. If periodic monitoring is enabled, it will be the detection device

which sends this status when danger disappears.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 52 53

Keine Kommentare

Zennio Z41 Handbuch Seite 42